Exploratory experimental investigations on post-tensioned structural glass beams

  • Christian Louter Steel Structures Laboratory (ICOM), School of Architecture, Civil and Environmental Engineering (ENAC), Ecole Polytechnique Federale de Lausanne (EPFL), Lausanne
  • Jagoda Cupac Steel Structures Laboratory (ICOM), School of Architecture, Civil and Environmental Engineering (ENAC), Ecole Polytechnique Federale de Lausanne (EPFL), Lausanne
  • Jean-Paul Lebet Steel Structures Laboratory (ICOM), School of Architecture, Civil and Environmental Engineering (ENAC), Ecole Polytechnique Federale de Lausanne (EPFL), Lausanne

Abstract

The mechanical response of post-tensioned glass beams is explored in this paper. This is done through bending experiments on post-tensioned glass beam specimens with either mechanically anchored or adhesively bonded steel tendons by which a beneficial pre-stress is inflicted on the glass beams. In addition, reference beams with identical geometry but without tendons are tested. From the results of the bending experiments it can be seen that the post-tensioned glass beams reach higher initial fracture loads than the reference glass beams. Furthermore, the post-tensioned glass beams develop a significant post-fracture reserve. From this it is concluded that post-tensioning a glass beam is a feasible concept, which provides increased initial fracture strength and enhanced post-fracture performance.

References

3MTM Scotch-WeldTM EPX Epoxy Adhesive DP490 Datasheet. (1996). Retrieved October 02, 2014, from http://catalogue.3m.eu/en_EU/EU-mro/3M_Adhesives/Structural_Adhesive_2_Part_Duo-Pack_-_Epoxy/Scotch-Weld%E2%84%A2_EPX~Epoxy_Adhesive~DP490/Epoxy_Adhesive

Belis, J., Callewaert, D., Delincé, D., & van Impe, R. (2009). Experimental failure investigation of a hybrid glass/steel beam. Engineering Failure Analysis, 16(4), 1163-1173. doi:10.1016/j.engfailanal.2008.07.011

Belis, J., Depauw, J., Callewaert, D., Delincé, D., & van Impe, R. (2009). Failure mechanisms and residual capacity of annealed glass/SGP laminated beams at room temperature. Engineering Failure Analysis, 16(6), 1866-1875. doi:10.1016/j.engfailanal.2008.09.023

Belis, J., Louter, C., Verfaille, K., van Impe, R., & Callewaert, D. (2006). The effect of post-tensioning on the buckling behaviour of a glass T-beam. In International Symposium on the Application of Architectural Glass ISAAG (pp. 129-136).

Belis, J., Mocibob, D., Luible, A., & Vandebroek, M. (2011). On the size and shape of initial out-of-plane curvatures in structural glass components. Construction and Building Materials, 25(5), 2700-2712. doi:10.1016/j.conbuildmat.2010.12.021

Bos, F., Veer, F., Hobbelman, G., & Louter, C. (2004). Stainless steel reinforced and post-tensioned glass beams. In ICEM12- 12th International Conference on Experimental Mechanics.

Correia, J. R., Valarinho, L., & Branco, F. A. (2011). Post-cracking strength and ductility of glass–GFRP composite beams. Composite Structures, 93(9), 2299-2309. doi:10.1016/j.compstruct.2011.03.018

Cruz, P. J. S., & Pequeno, J. (2008). Timber-glass composite beams: mechanical behaviour & architectural solutions. In Challenging Glass (pp. 439-448).

EN 1993-1-4. Eurocode 3- Design of steel structures - Part 1-4: General rules - Supplementary rules for stainless steels (2006).

EN 572-2. (2004). Glass in building – Basic soda lime silicate glass products – Part 2: Float glass.

Freytag, B. (2004). Glass-concrete composite technology. Structural Engineering International, 14(2), 111-117. doi:10.2749/101686604777963991

Jordão, S., Pinho, M., Martins, J. P., Santiago, A., & Neves, L. C. (2014). Behaviour of laminated glass beams reinforced with pre-stressed cables. Steel Construction, 7(3), 204-207. doi:10.1002/stco.201410027

Kreher, K., & Natterer, J. (2004). Timber-glass-composite girders for a hotel in Switzerland. Structural Engineering International, 2, 149-151.

Louter, C., Belis, J., Veer, F., & Lebet, J.-P. (2012). Structural response of SG-laminated reinforced glass beams; experimental investigations on the effects of glass type, reinforcement percentage and beam size. Engineering Structures, 36, 292-301. doi:10.1016/j.engstruct.2011.12.016

Louter, C., Cupać, J., & Debonnaire, M. (2014). Structural glass beams pre-stressed by externally bonded tendons. In GlassCon Global (pp. 460-469).

Louter, C., Nielsen, J. H., & Belis, J. (2013). Exploratory experimental investigations on post-tensioned structural glass beams. In The 2nd International Conference on Structures and Architecture ICSA 2013 (pp. 358-365).

Louter, C., Pérez, A., Jordan, T., & Lebet, J.-P. (2013). Post-tensioned structural glass beams – Experimental investigations. In COST Action TU0905 Mid-term Conference on Structural Glass (pp. 277-284).

Ølgaard, A. B., Nielsen, J. H., & Olesen, J. F. (2009). Design of mechanically reinforced glass beams: modelling and experiments. Structural Engineering International, 19(2), 130-136. doi:10.2749/101686609788220169

Palumbo, D., Palumbo, M., & Mazzucchelli, M. (2005). A new roof for the XIIIth century “Loggia de Vicari” ( Arquà Petrarca - PD - Italy ) based on structural glass trusses: a case study. In Glass Processing Days (pp. 434-435).

Schober, H., Gerber, H., & Schneider, J. (2004). Ein Glashaus für die Therme in Badenweiler. Stahlbau, 73, 886-892.

Speranzini, E., & Agnetti, S. (2014). Strengthening of glass beams with steel reinforced polymer (SRP). Composites Part B: Engineering, 67, 280-289. doi:10.1016/j.compositesb.2014.06.035

Stelzer, I. (2010). High performance laminated glass. In Challenging Glass 2 (pp. 467-474).

Weller, B., & Engelmann, M. (2014). Deformation of Spannglass beams during post-tensioning. In Challenging Glass 4 & COST Action TU0905 Final Conference (pp. 285-294).

Weller, B., Meier, A., & Weimar, T. (2010). Glass-steel beams as structural members of façades. In Challenging Glass 2 (pp. 517-524).
How to Cite
LOUTER, Christian; CUPAC, Jagoda; LEBET, Jean-Paul. Exploratory experimental investigations on post-tensioned structural glass beams. Journal of Facade Design and Engineering, [S.l.], v. 2, n. 1-2, p. 3-18, may 2015. ISSN 2213-3038. Available at: <https://journals.open.tudelft.nl/index.php/jfde/article/view/879>. Date accessed: 21 mar. 2019. doi: https://doi.org/10.7480/jfde.2014.1-2.879.
Published
2015-05-07